Steam Room Installation in Palm Beach, FL
Steam rooms built the way they should be: full waterproofing membrane, sized generator, sloped ceiling, and drainage planned before the stone is ordered.
Steam Rooms Built for Palm Beach Homes
A steam room is the least forgiving thing you can build in an old house. It is a sealed box running near saturation, and every failure is a water failure. In a 1920s Palm Beach house with original plaster, pecky cypress, and hollow tile construction, a leaking steam enclosure does not stay a bathroom problem for long.
So we build from the waterproofing out. Continuous membrane behind every surface, corners and the bench-to-wall junction detailed properly, a ceiling sloped to carry condensation to the walls instead of dropping it on the occupant, and a drain sized for the real volume of water the room produces.
Generator sizing and placement are the other half. An undersized generator never reaches temperature and runs constantly; a correctly sized one placed in a remote service closet is close to silent in the room. On estate projects we locate it where service access is easy and where nobody hears it, then commission the whole system before handover.
A steam shower in a Midtown primary bath or a full steam suite in an Estate Section wellness wing, we build both vapor-tight, with the waterproofing documented before anything is covered up.
Frequently Asked Questions
How much does a steam room cost in Palm Beach?
Most island steam rooms run $14,000 to $45,000+ installed. Stone selection, glass, bench detailing, and the waterproofing scope drive the number far more than the generator itself does.
What size generator do I need?
Sizing follows the room's cubic volume adjusted for stone, glass, and exterior walls. A typical residential enclosure needs 7 to 12 kW; heavy stone and a tall ceiling push it higher. We calculate rather than estimate.
Where does the generator go?
In a ventilated service closet, an attic space, or a mechanical room within the manufacturer's allowable pipe run. Remote placement keeps the room quiet and makes annual descaling and service straightforward.
Can a steam room go into a historic Palm Beach house?
Yes, with care. We build the enclosure as a fully waterproofed insert rather than relying on original wall construction, and route services through later partitions so original plaster and cypress are left intact.
Can a steam room and sauna share a space?
They can share a wellness suite and a mechanical wall, but they must remain separate enclosures. Dry heat and saturated steam need different ventilation, different surfaces, and different drainage.
How long does installation take?
Typically two to four weeks on site: waterproofing and inspection, stone or tile setting and cure, glass templating and fabrication, then generator installation and commissioning.
Request a free sauna consultation or email contact@saunashop.us.